2000 Rover Mini

Nearside Front Wheel bearing has slight play (5.1.3 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Battery insecure and likely to cause a short circuit (4.13 (a) (ii))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Offside Rear Parking brake inoperative on one side (1.4.1 (a))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Nearside Front Wheel bearing has slight play (5.1.3 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Emissions not tested (8.2.1.2 (d))

Exhaust catalytic converter missing where one was fitted as standard (8.2.1.1 (a))

Nearside Front Integral body structure inadequately repaired such that structural rigidity is significantly reduced floor area/s (6.1.1 (d) (i))

Nearside Front Wheel bearing has excessive play (5.1.3 (a) (i))

Nearside Headlamp aim too high (4.1.2 (a))

Offside Front Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced floor area/s (6.1.1 (c) (i))

Offside Rear Parking brake inoperative on one side (1.4.1 (a))

Offside Rear Service brake lagging in operation (1.2.1 (d))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Brakes imbalanced across an axle (1.2.1 (b) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Rear fog lamp not working (4.5.1 (a) (ii))

Offside Front Lower Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Suspension component mounting repair covered in underseal (5.3.6 (a) (i))

Exhaust catalytic converter missing where one was fitted as standard (8.2.1.1 (a))

Nearside Rear Parking brake inoperative on one side (1.4.1 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Brakes imbalanced across an axle (1.2.1 (b) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Service brake efficiency below requirements (1.2.2 (a) (i))

Nearside Rear Service brake has no recorded effort at a wheel (1.2.1 (a) (ii)) DANGEROUS

Suspension component mounting repair covered in underseal (5.3.6 (a) (i))

Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security under floor area/s (6.2.2 (d) (i))

Suspension component mounting repair covered in underseal underbody/floor area/s (5.3.6 (a) (i))

Nearside Headlamp aim too high (4.1.2 (a))

Offside Front Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i))

Offside Rear Parking brake inoperative on one side (1.4.1 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security under floor area/s (6.2.2 (d) (i))

Suspension component mounting repair covered in underseal underbody/floor area/s (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Upper Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Nearside Front Suspension component mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected (5.3.6 (a) (ii)) DANGEROUS

Nearside Rear Suspension component mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected (5.3.6 (a) (ii)) DANGEROUS

Offside Front Suspension component mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected (5.3.6 (a) (ii)) DANGEROUS

Offside Rear Suspension component mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected (5.3.6 (a) (ii)) DANGEROUS

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Front Track rod end ball joint has slight play (2.2.B.1f)

Front Tyre worn close to the legal limit (4.1.E.1)