1997 Mitsubishi Fto

Front brake pads wearing thin

Offside outer sill heavily corroded

Park brake both sides performance could be better

Rear chassis starting to corrode

Underbody along inner sills corroding

Oil leak (Not excessive)

Underbody along inner sill starting to show corrosion

Oil leak (Not excessive)

Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Rear Parking brake inoperative on one side (1.4.1 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

All steering & suspension shows general age related wear & surface corrosion

Both sides front roll bar links slight play in ball joints

Both sides front roll bar links slight play in ball joints

Oil leak (Not excessive)

Nearside Front Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Offside Front Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Rear Service brake excessively binding (1.2.1 (f))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Service brake efficiency below requirements (1.2.2 (a) (i))

Nearside Front Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Offside Front Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Offside Rear Position lamp not working (4.2.1 (a) (ii))

Oil leak, but not excessive (8.4.1 (a) (i))

brake dust back plates corroded

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

brake dust back plates corroded

Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Inner Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Rear Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Exhaust hydrocarbon content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Offside Front Lower Suspension component ball joint excessively worn (5.3.4 (a) (i))

Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Inner Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Rear Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

both front tyres worn on inner edges

both rear brake back plates corroded

both rear tyres perished on inner sidewalls

Nearside Front Suspension component mounting prescribed area is excessively corroded inner rear wishbone mount (2.4.A.3)

Offside Front Suspension component mounting prescribed area is excessively corroded inner rear wishbone mount (2.4.A.3)

Front Exhaust has a minor leak of exhaust gases (7.1.2)

both front tyres worn on inner edges

both rear brake back plates corroded

both rear tyres perished on inner sidewalls

Exhaust has a minor leak of exhaust gases (7.1.2)

Offside Front tyre worn on inner edge

Offside Rear tyre perished/cracking on outer wall

Offside Front Brake pipe slightly corroded (3.6.B.2c)

both inner rear sills corroded and in need of attention

all brake discs worn

drivers seat in poor condition

engine slightly noisey

fuel filler pipes corroded

general underbody corrosion

inner sills corroded

marks to windscreen

rear chassis legs & floors corroded

slight knocking from n/s/f suspension

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Front Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Headlamp not working on dipped beam (1.7.5a)

Parking brake: efficiency below requirements (3.7.B.7)

Service brake: efficiency below requirements (3.7.B.7)

Windscreen wiper does not clear the windscreen effectively (8.2.2)

all brake discs worn

drivers seat in poor condition

engine noisey

front brake pads getting low

fuel filler pipes corroded

general under body corrosion

inner sills corroded

marks to windscreen

rear chassis legs & floors corroded

slight binding n/s/r brake

slight rattle from n/s/f suspension area

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Vehicle structure has slight corrosion (6.1.A.1)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

An item not tested (Manual)

Nearside Headlamp not working on dipped beam (1.7.5a)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Vehicle structure has slight corrosion (6.1.A.1)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Emissions not tested (7.0)

Emissions not tested (7.0)

Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Front Mechanical brake component has restricted free movement (3.5.1k)

Nearside Rear Brake pipe excessively corroded (3.6.B.2c)

Nearside Rear Mechanical brake component has restricted free movement (3.5.1k)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Body has slight corrosion (6.1.B.2)

rear chassis corroded

Under-trays fitted obscuring some underside components

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Horn not working (1.6.2a)

Nearside Rear Brake lining(s) less than 1.5 mm thick (3.5.1g)

Under-trays fitted obscuring some underside components

Nearside Headlamp excessively deteriorated so that the light output is severely reduced (1.7.5a)

Nearside Rear Upper Tie bar/rod has excessive play in a pin/bush (2.4.G.2)

Nearside Steering rack gaiter split (2.2.D.2d)

Offside Rear Brake pipe excessively corroded (3.6.B.2c)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Upper Tie bar/rod has excessive play in a pin/bush (2.4.G.2)

Offside Rear fog lamp not working (1.3.2b)

front brake application uneven (3.7.B.2)

Rear Brake pipe slightly corroded (3.6.B.2c)

Rear Service brake: service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

knock on front nearside suspension

Nearside Inner Front Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Offside Headlamp aim too high (1.8)

Offside Inner Front Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Service brake: service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Nearside Inner Front Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Offside Inner Front Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Service brake: service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Front Brake pad(s) wearing thin (3.5.1g)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

braking efforts low

Offside Front Headlamp aim too low when the centre of the headlamp is below 850mm from the ground (1.6.B2)