1989 Austin Mini Racing Flame

Nearside Front Wheel bearing has excessive play (5.1.3 (a) (i))

Rear fog lamp switch not operating in accordance with the requirements (4.5.3 (a))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Service brake efficiency less than 50% of the required value (1.2.2 (a) (ii)) DANGEROUS

Offside Front Wheel bearing has slight play (5.1.3 (a) (i))

Nearside Front Wheel bearing has slight play (5.1.3 (a) (i))

Offside Front Wheel bearing slightly noisy (5.1.3 (b) (i))

Steering column top bearing slightly worn Slight up and down movement in steering column but not excessive (2.2.2 (b))

Front Headlamp aim beam image obviously incorrect main beam is dimmer than the dip beam , plus no clear pattern , believe incorrectly wired. (1.8.A.1b)

Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Front Front wheel bearing rough when rotated (2.5.A.2)

Nearside Headlamp aim too high (1.8)

Nearside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings sub frame holed (6.1.B.2)

Offside Outer Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings sub frame holed (6.1.B.2)

Nearside Front Front suspension has slight play in a upper suspension ball joint (2.5.B.1a)

Offside Front Front suspension has slight play in a upper suspension ball joint (2.5.B.1a)

Parking brake lever has no reserve travel (3.1.6b)

Exhaust emissions carbon monoxide content excessive (7.3.B.1a)

Nearside Front Tyre not fitted in accordance with side wall instructions (4.1.D.1f)

Nearside Rear Tyre not fitted in accordance with side wall instructions (4.1.D.1f)

Offside Front constant velocity joint gaiter insecurely mounted to its housing (2.5.C.1a)

Offside Rear Tyre not fitted in accordance with side wall instructions (4.1.D.1f)

Offside rear brake recording little or no effort (3.7.B.5a)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Rear Exhaust system not adequately supported (7.1.1)

Offside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3) DANGEROUS

Brake hydraulic reservoir fluid close to minimum level (3.6.G.1b)

Front Direction indicator slightly discoloured (1.4.A.2f)

Exhaust emissions carbon monoxide content excessive (7.3.B.1a)

Horn not working (1.6.2a)

Nearside Front Front position lamp(s) not working (1.1.A.3b)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Rear Rear fog lamp not working (1.3.2b)

Position lamp switch faulty (1.1.A.1)

Service brake: efficiency below requirements (3.7.B.7)

Direction indicators not working (1.4.A.2c)

Exhaust emissions carbon monoxide content excessive (7.3.B.1a)

Hazard warning switch faulty (1.4.B.1d)

Nearside Headlamp aim too low (1.8)

Nearside Steering rack gaiter split (2.2.D.2d)

Offside Steering rack gaiter split (2.2.D.2d)

All position lamps not working (1.1.A.3b)

Exhaust emissions carbon monoxide content excessive (7.3.B.1a)

Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Front Windscreen has a sticker or other obstruction encroaching by more than 10mm within zone 'A' (8.3.1b)

Front Windscreen has a sticker or other obstruction encroaching into the swept area by more than 40mm outside zone 'A' (8.3.1e)

Front registration plate insecure (6.3.1b)

Hazard warning lamps not flashing in phase, with ignition off (1.4.B.1f)

Hazard warning lamps not flashing in phase, with ignition on (1.4.B.1f)

Hazard warning switch faulty (1.4.B.1d)

Nearside rear brake recording little or no effort (3.7.B.5a)

Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Registration plate lamp not working (1.1.5c)

rear brake application uneven (3.7.B.2)

Brake pipe slightly corroded (3.6.B.2c)

Front Brake pipe slightly corroded (3.6.B.2c)

Front brake disc slightly pitted (3.5.1h)

Fuel pipe/s corroded

Oil leak

Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

corrosion rear subfram