2020 Audi A3

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Nearside Front Headlamp aim too low (4.1.2 (a))

Nearside Front Coil spring corroded (5.3.1 (b) (i))

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Offside Rear position lamp lens slightly defective

Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Undertrays fitted

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Undertrays fitted

Brake disc worn, pitted or scored, but not seriously weakened all x 4 (1.1.14 (a) (ii))

Front Suspension arm pin or bush worn but not resulting in excessive movement both sides deteriorated (5.3.4 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Engine covers fitted obscuring some components in the engine bay

Under-trays fitted obscuring some underside components

Nearside Front Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

Nearside Front Tyre has a tear, caused by separation or partial failure of its structure (4.1.D.1b)

Offside Front Tyre has a tear, caused by separation or partial failure of its structure (4.1.D.1b) DANGEROUS

Engine covers fitted obscuring some components in the engine bay

Under-trays fitted obscuring some underside components

Offside Front Brake pad(s) wearing thin (3.5.1g)

Under-trays fitted obscuring some underside components

Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Under-trays fitted obscuring some underside components

Offside Front Brake pad(s) wearing thin (3.5.1g)

Offside Rear Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)