1987 Land Rover Defender

All position lamps adversely affected by the operation of another lamp (4.2.3 (c))

Emissions not tested (8.2.2.2 (e))

Front Exhaust system insecure (6.1.2 (a))

Nearside Rear Brake drum contaminated Brake drum moist (1.1.14 (b))

Parking brake lever has excessive movement indicating incorrect adjustment (1.1.6 (c))

Rear All position lamps adversely affected by the operation of another lamp Rear lights turn off when dip beam is turned on (4.2.3 (c))

Central Brake pipe corroded, covered in grease or other material (1.1.11 (c))

General underside corrosion

Nearside Front Valve stem slightly damaged (5.2.3 (j))

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Offside Rear Upper Shock absorbers has a slightly worn bush (5.3.2 (c))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Front Brake pad(s) wearing thin (3.5.1g)

offside front chassis corroded

Centre Rear Brake pipe slightly corroded (3.6.B.2c)

Front Brake pad(s) wearing thin (3.5.1g)

Offside Brake pipe slightly corroded front to rear (3.6.B.2c)

play in steering box

tested wet

under body repairs

Offside Front Tyre not fitted in accordance with side wall instructions (4.1.D.1f)

Centre Rear Brake pipe slightly corroded (3.6.B.2c)

Front Brake pad(s) wearing thin (3.5.1g)

Offside Brake pipe slightly corroded front to rear (3.6.B.2c)

play in steering box

tested wet

under body repairs

play in nearside front wheel bearing

play in propshaft ujs

Exhaust has a major leak of exhaust gases (7.1.2)

Front Panhard rod has excessive play in a pin/bush (2.4.G.2)

Nearside Rear Suspension has inadequate clearance with the bump stop (2.4.A.1a)

Offside Front Suspension has inadequate clearance with the bump stop (2.4.A.1a)

Parking brake: efficiency below requirements (3.7.B.7)

Power steering malfunctioning (2.3.3a)

Rear Suspension arm has excessive play in a pin/bush (2.4.G.2)

Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)