2000 Land Rover Range Rover

Nearside Front Lower Suspension component ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Front Lower Suspension component ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Front Lower Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Offside Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Exhaust mounting defective (6.1.2 (a))

Front Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Rear Brake pipe excessively corroded (1.1.11 (c))

Offside Brake pipe excessively corroded front to rear (1.1.11 (c))

Offside Rear Brake pipe excessively corroded (1.1.11 (c))

Front Oil leak, but not excessive (8.4.1 (a) (i))

Offside Track rod end ball joint has slight play to steering box (2.1.3 (b) (i))

Direction indicator slightly discoloured both rear (4.4.3 (a))

both front air bags slightly perished

exhaust rubber snapped but exhaust still secure

slight corrosion rear brake pipes both sides

Offside Rear Brake pipe slightly corroded both main runs side of tank (3.6.B.2c)

Direction indicator slightly discoloured both rear (1.4.A.2f)

all brake pipes heavily greased

Brake pipe slightly corroded (3.6.B.2c)

Direction indicator slightly discoloured (1.4.A.2f)

Handbrake Lever Approaching The End Of It's Travel

Oil Leak(S)

Rear Brake Pipes Slightly Corroded

Slight Leak From Power Steering

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Nearside Headlamp insecure (1.7.3)

Nearside Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear position lamp(s) incorrect colour (1.1.A.3e)

Nearside Registration plate lamp not working (1.1.C.1d)

Nearside Stop lamp emits other than a steady red light (1.2.1e)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Rear Seat belt locking mechanism does not secure or release (5.2.5a)

Exhaust has a minor leak of exhaust gases (7.1.2)

Exhaust has part of the system slightly deteriorated (7.1.1a)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Nearside Rear Direction indicator slightly discoloured (1.4.A.2f)

Nearside Stop lamp obscured but not more than 50% (1.2.1c)

Offside Headlamp aim too high (1.8)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Oil leak

Parking brake lever has little reserve travel (3.1.6b)

Power steering pipe(s) or hose(s) has slight seepage (2.3.3b)

Rear brake discs worn and corroded

Both Rear Tyres Have Nails In Them

Nearside Front Tyre Close To Legal Tread Depth Limit Especially On The Outer Edge

Nearside Rear Lamp Unit Damaged But Had Temporary Repair

Offside Rear & Centre Rear Seat Belt Stalks - Covers Missing

Rear Brake Discs Corroded, Scored & Worn

Rear Brake pad(s) wearing thin (3.5.1g)

Spare Tyre - Flat & Sidewall Distorted & Nail In It

Centre Exhaust has a major leak of exhaust gases (7.1.2)

Both Rear Tyres Have Nails In Them

Nearside Front Tyre Close To Legal Tread Depth Limit Especially On The Outer Edge

Nearside Rear Lamp Unit Damaged But Had Temporary Repair

Offside Rear & Centre Rear Seat Belt Stalks - Covers Missing

Rear Brake Discs Corroded, Scored & Worn

Rear Brake pad(s) wearing thin (3.5.1g)

Spare Tyre - Flat & Sidewall Distorted & Nail In It

Oil leak

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Front Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Oil leak