1998 Jaguar Xjr

Brake pipe corroded, covered in grease or other material Front to rear (1.1.11 (c))

Brake pipe corroded, covered in grease or other material Front to rear (1.1.11 (c))

Nearside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Nearside Rear Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Rear Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Rear Lower Shock absorbers has a slightly worn bush both sides (5.3.2 (c))

Registration plate deteriorated but not likely to be misread both (0.1 (b))

Nearside Front Lower Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Front Upper Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Fuel Pipe/s corroded ()

corrosion to rear suspension area

Nearside Front Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

corrosion to rear suspension area

battery light illuminated

corrosion to underside

heavily undersealed

Registration plate lamp not working (1.1.C.1d)

battery light illuminated

corrosion to underside

heavily undersealed

Electronic stability system warning lamp indicates a fault (3.4.1c)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Nearside Front Electrical wiring insecure (1.9.2a)

Nearside Headlamp aim too low (1.8)

Offside Front Electrical wiring insecure (1.9.2a)

Parking brake: efficiency below requirements (3.7.B.7)

Registration plate lamp not working (1.1.C.1d)

corrosion to front and rear subframe areas

heavily undersealed

play in o/s/f upper ball joint

Nearside Headlamp aim too high (1.8)

Offside Front position lamp(s) not working (1.1.A.3b)

Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

play in o/s/f upper ball joint

both rear tyres 1.6mm measured within the centre 3/4 band

o/s/r brake hose twisted

Nearside Headlamp not in good working order adversely affecting beam image (1.2.4a)