1999 Mitsubishi Fto

Offside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Rear Brake disc worn, but not excessively (1.1.14 (a) (i))

Offside Front Inner Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Rear Brake lining(s) wearing thin (1.1.13 (a) (ii))

Offside Front Inner Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Stop lamp(s) not working (4.3.1 (a) (ii))

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Rear Brake lining(s) wearing thin (1.1.13 (a) (ii))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive two places (5.3.6 (a) (i))

Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Headlamp has a product on the lens but not seriously reducing light output both sides (4.1.4 (b))

Offside Rear Seat belt webbing slightly damaged or frayed (7.1.2 (b) (ii))

Parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (1.4.2 (a) (i))

Rear Anti-roll bar linkage ball joint dust cover severely deteriorated both sides (5.3.4 (b) (i))

Suspension component mounting prescribed area is corroded but not considered excessive front and rear (5.3.6 (a) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Headlamp has a product on the lens but not seriously reducing light output both sides (4.1.4 (b))

Nearside Windscreen washer provides insufficient washer liquid (3.5 (a))

Offside Rear Seat belt webbing slightly damaged or frayed (7.1.2 (b) (ii))

Parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (1.4.2 (a) (i))

Rear Anti-roll bar linkage ball joint dust cover severely deteriorated both sides (5.3.4 (b) (i))

Suspension component mounting prescribed area is corroded but not considered excessive front and rear (5.3.6 (a) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Brake pipe slightly corroded all (3.6.B.2c)

Lower Body has slight corrosion (6.1.B.2)

Nearside Rear Vehicle structure has slight corrosion (6.1.B.2)

Rear Trailing arm rubber bush deteriorated but not resulting in excessive movement both side (2.4.G.2)

Vehicle structure has slight corrosion (6.1.B.2)

front and rear suspensions system corroded

Nearside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Nearside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Offside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Brake pipe slightly corroded all (3.6.B.2c)

Lower Body has slight corrosion (6.1.B.2)

Nearside Rear Vehicle structure has slight corrosion (6.1.B.2)

Rear Trailing arm rubber bush deteriorated but not resulting in excessive movement both side (2.4.G.2)

Vehicle structure has slight corrosion (6.1.B.2)

front and rear suspensions system corroded

Exhaust has a minor leak of exhaust gases (7.1.2)

Offside Rear Vehicle structure has slight corrosion (6.1.B.2)

Front Exhaust has a minor leak of exhaust gases (7.1.2)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Nearside Rear Stop lamp not working (1.2.1b)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Nearside Front position lamp(s) not working (1.1.A.3b)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Offside Front Headlamp excessively deteriorated so that the light output is severely reduced (1.7.5a)

Offside Steering rack gaiter split (2.2.D.2d)

Nearside Front Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

Centre Rear Exhaust has part of the system slightly deteriorated (7.1.1a)

Nail in offside rear tyre

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Non obligatory mirror damaged

Nearside Outer Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)