2013 Mazda 3

Front Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Tyre slightly damaged/cracking or perishing perishing inner edge (5.2.3 (d) (ii))

underbody surface rust

Nearside Front Tyre slightly damaged/cracking or perishing perishing in tread (5.2.3 (d) (ii))

underbody has surface rust

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))

Offside Rear Tyre has a cut but not deep enough to reach the ply or cords (5.2.3 (d) (i))

Nearside Rear Anti-roll bar linkage ball joint has slight play could cause noise advise early replacement (5.3.4 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge close to wear bars (5.2.3 (e))

nearside rear tyre uneven wear on the inner edge

offside front tyre close to the wear bars

front brake pads getting low

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

front brake pads getting low