2009 Rieju RS2 50

Brake pedal is bent but brake can still be readily applied (1.1.2 (d))

Clutch lever bent (6.2.7 (b))

Drive chain slightly tight (6.1.7 (k) (i))

Brake pedal is bent but brake can still be readily applied (1.1.2 (d))

Clutch lever bent (6.2.7 (b))

Drive chain slightly tight (6.1.7 (k) (i))

Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Front Headlamp aim not tested dip beam not working (4.1.2 (b))

Nearside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Rear Brake indicates excessive fluctuation of brake effort Badly warped disc (1.2.1 (e))

Offside Rear Brake pad(s) less than 1.0 mm thick (1.1.13 (a)) DANGEROUS

Offside Front Shock absorber has a light misting of oil (5.3.2 (b))

Offside Front wiring to front brake switch very loose, could fall off

Central Front Suspension pin, bush or joint worn but not resulting in excessive movement FRONT FORKS SHOWING SIGNS OF SLIGHTLY WORK BUSHINGS. MONITOR. (5.3.4 (a) (i))

Offside Front FRONT CALIPER HAS SLIGHT PLAY BUT DOESN'T AFFECT OPERATION. MONITOR

Drive chain worn but not considered excessive (6.1.7 (c) (i))

Front Wheel bearing has slight play (5.1.3 (a) (i))

L/H lock stop damaged - handlebar close to tank on full lock

Wheel alignment slightly misaligned (2.4 (a))

Footrest insecure R/H front (6.2.12 (a))

Handlebar restricted in free movement from lock to lock Front brake hitting inside fairing on full L/H lock (2.1.4 (c))

Headlamp aim too low (4.1.2 (a))

Drive chain so worn it is likely to fail Horseshoe clip missing (6.1.7 (c) (ii)) DANGEROUS

Drive chain worn but not considered excessive (6.1.7 (c) (i))

Front Wheel bearing has slight play (5.1.3 (a) (i))

L/H lock stop damaged - handlebar close to tank on full lock

Wheel alignment slightly misaligned (2.4 (a))

Exhaust noisy (7.1.2)

front tyre slightly perished

Front Brake lever is bent but brake can still be readily applied (3.1.3c)

Drive chain excessively loose (6.2.1d)

Front Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Headlamp at least one does not illuminate on dipped beam (1.2.2a(i))

Offside Front shock absorber seal failed and leaking oil (2.3.3)

Offside Brake disc(s) friction surface contaminated by oil or grease (3.2.A1k) DANGEROUS

Front Brake lever is bent but brake can still be readily applied (3.1.3c)

1. Slight play in top steering head bearings. 2. Both rear indicator bulbs becoming faded. 3. Rear brake pads wearing low. 4. Slight damage to front brake lever.