2003 Yamaha DT125

Front wheel bearings are slightly rough (2.3.5b)

Front wheel bearings have slight free play (2.3.5b)

Rear shock absorber has a slightly reduced damping effect (2.4.A.3b)

Headlamp aim beam image kick up to the offside (1.6)

Front Wheel spoke slightly loose. (4.2.1b)

Rear Roller brake test indicates slight fluctuation of brake effort (3.3.A1d)

rear suspension lower link slighty worn

Drive chain worn but not considered excessive (6.2.1e)

Exhaust slightly deteriorated (7.1.1a)

Front Wheel spoke slightly loose. (4.2.1b)

Nearside Front shock absorber has light misting of stanchion (2.3.3)

front brake lever end broken off but is still long enough to be applied

more than one front wheel spoke slightly loose

no direction indicators fitted,tested as off road vehicle

Registration plate delaminated (6.3.1.d)

Front Wheel spoke slightly loose. (4.2.1b)

no direction indicators fitted,tested as off road vehicle

rear brake slighty rubbing

Front Wheel spoke slightly loose. (4.2.1b)

Brake lever is bent and the brake cannot be readily applied (3.1.3c)

Headlamp aim too low (1.6)

Rear suspension movement is excessively stiff (2.4.A.3b)

Front Wheel spoke slightly loose. (4.2.1b)

clutch lever bent

Front Brake disc(s) excessively worn (3.2.A1l)

Front Brake lever is so short and the brake cannot be readily applied (3.1.3c)

Rear Stop lamp affected by the operation of another lamp (1.3.2)

Rear Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))

Rear Wheel has an excessively distorted bead rim. (4.2.2)

Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Front Wheel spoke slightly loose. (4.2.1b)

Rear Wheel spoke slightly loose. (4.2.1b)

Rear position lamp slightly affected by the operation of another lamp (1.1.3b)