2010 Honda Cr-z

Nearside Rear Tyre worn close to legal limit/worn on edge Wearing slightly unevenly on inner edge (5.2.3 (e))

Offside Front Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Nearside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Nearside Front Upper Anti-roll bar ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Offside Front Upper Anti-roll bar ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Front Anti-roll bar linkage ball joint has slight play advise repair (5.3.4 (a) (i))

OSR lamp has condensation but not affecting light output - advise repair

Plastic sill and undercovers fitted as standard not allowing full inspection

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Anti-roll bar ball joint has slight play advise replacement (5.3.4 (a) (i))

Plastic sill and undercovers fitted as standard not allowing full inspection

Plastic undercovers fitted as standard not allowing full inspection

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Anti-roll bar ball joint has slight play (5.3.4 (a) (i))

Rear Brake pad(s) wearing thin inner pads (1.1.13 (a) (ii))

plastic sill and under covers as fitted as standard not allowing full inspection

Nearside Rear Tyre slightly damaged/cracking or perishing advise replacement (5.2.3 (d) (ii))

Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Rear lamp is misted up . due to water in the lamp

Offside Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

plastic sill and under covers not allowing full inspection

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Front Nail in tyre ()

Offside Front Brake pad(s) wearing thin (3.5.1g)

n/s/r tyre 3 mm

Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)