2007 Mazda MX-5

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Anti-roll bar ball joint has slight play (5.3.4 (a) (i))

Offside Front Anti-roll bar ball joint has slight play (5.3.4 (a) (i))

Offside Rear service brake poor

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

slight surface corrosion

Offside handbrake

Nearside Rear Tyre worn close to legal limit/worn on edge Worn to 2.5mm (5.2.3 (e))

Offside Rear Tyre worn close to legal limit/worn on edge Worn to 2.5mm (5.2.3 (e))

Nearside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Rear Upper Suspension component pin or bush slightly worn tie bar bush wearing (5.3.4 (a) (i))

Offside Front Anti-roll bar linkage ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Rear Upper Suspension component pin or bush slightly worn tie bar bush wearing (5.3.4 (a) (i))

Offside Rear Registration plate lamp insecure (1.1.C.1c)

Offside Rear Registration plate lamp not working (1.1.C.1d)

Front brake disc in such a condition that it is seriously weakened (3.5.1i)

Nearside Front Braking system leaking caliper pipe (3.6.A.1)

Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

under trays fitted to vehicle

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

under trays fitted to vehicle

Front Brake pad(s) wearing thin (3.5.1g)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Offside Rear Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Nearside Front Anti-roll bar linkage fractured (2.4.G.1)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Headlamp aim too low (1.8)

Nearside Rear Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Offside Rear Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Front Anti-roll bar linkage insecure (2.4.G.1)

Offside Rear Tyre has a lump, caused by separation or partial failure of its structure (4.1.D.1b)