2008 Yamaha Yzf

Rear Suspension rod pin, bush or joint worn but not resulting in excessive movement linkage has play in lower bearing or bush (5.3.4 (a) (i))

Offside Front Shock absorber has a serious fluid leak (5.3.2 (b))

Drive chain slightly loose (6.1.7 (c) (i))

Rear Suspension rod pin, bush or joint worn but not resulting in excessive movement linkage has play in lower bearing or bush (5.3.4 (a) (i))

Shock absorber has a light misting of oil R/H fork seal (5.3.2 (b))

Suspension pin, bush or joint worn but not resulting in excessive movement Rear suspension linkage bearings have slight up & down play (5.3.4 (a) (i))

Drive chain horseshoe locking device incorrectly fitted Fitted backwards (6.1.7 (j) (i))

Footrest missing R & L - Rear (6.2.12 (a))

Rear Brake fluid significantly below minimum mark (1.1.10 (d) (ii))

Front Brake pad(s) less than 1.0 mm thick Squeaking when applied (1.1.13 (a)) DANGEROUS

Shock absorber has a light misting of oil R/H fork seal (5.3.2 (b))

Suspension pin, bush or joint worn but not resulting in excessive movement Rear suspension linkage bearings have slight up & down play (5.3.4 (a) (i))

Shock absorber has a light misting of oil R/H fork seal (5.3.2 (b))

Suspension arm pin, bush or joint worn but not resulting in excessive movement Rear linkage bearings have slight up & down play (5.3.4 (a) (i))

Rear Brake pad(s) less than 1.0 mm thick Linings worn on to metal (1.1.13 (a)) DANGEROUS

Drive chain slightly tight (6.1.7 (k) (i))

Shock absorber has a light misting of oil R/H fork seal (5.3.2 (b))

Suspension arm pin, bush or joint worn but not resulting in excessive movement Rear linkage bearings have slight up & down play (5.3.4 (a) (i))

Suspension arm pin, bush or joint worn but not resulting in excessive movement Swinging arm bearings (5.3.4 (a) (i))

Headlamp at least one does not illuminate on dipped beam (1.2.2a(i))

Headlamp at least one does not illuminate on main beam (1.2.2a(ii))

Rear Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))

Clutch lever bent (6.2.1g)

Drive chain worn but not considered excessive (6.2.1e)

Front Drive chain sprocket slightly worn (6.2.1e)

Rear Drive chain sprocket slightly worn (6.2.1e)

Headlamp aim too high (1.6)

Rear Brake pad(s) less than 1.5 mm thick (3.2.A1f(i))

Rear reflector on motorcycle missing (1.4.1)

Clutch lever bent (6.2.1g)

Drive chain worn but not considered excessive (6.2.1e)

Front Drive chain sprocket slightly worn (6.2.1e)

Rear Drive chain sprocket slightly worn (6.2.1e)

Rear suspension bush has slight free play (2.4.A2a(i))

Front Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))

Rear suspension bush has slight free play (2.4.A2a(i))