2007 Mazda 6

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Wheel bearing slightly noisy (5.1.3 (b) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Under side of vehicle corroded body/suspension

Nearside Headlamp has a product on the lens so that the light output is severely reduced (4.1.4 (b))

Nearside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Front Lower Suspension arm pin or bush excessively worn Inner bush (5.3.4 (a) (i))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Headlamp has a product on the lens so that the light output is severely reduced (4.1.4 (b))

Offside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Offside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Under side of vehicle corroded body/suspension

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

underside corrosion

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

underside corrosion

Nearside Front Service brake excessively fluctuating (1.2.1 (e))

Stop lamp(s) not working centre (4.3.1 (a) (ii))

Nearside Front Tyre worn close to legal limit/worn on edge 1.6mm (5.2.3 (e))

Nearside Headlamp aim too low (4.1.2 (a))

Offside Front Service brake binding but not excessively (1.2.1 (f))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Offside Front Lower Suspension arm ball joint dust cover no longer prevents the ingress of dirt rear arm (5.3.4 (b) (ii))

Nearside Rear Tyre has ply or cords exposed (5.2.3 (d) (ii)) DANGEROUS

Suspension component mounting prescribed area is corroded but not considered excessive offside and nearside inner sills at rear in mounting areas (5.3.6 (a) (i))

Front Brakes imbalanced across an axle (1.2.1 (b) (i))

Offside Rear Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Offside Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Suspension component mounting prescribed area is corroded but not considered excessive offside and nearside inner sills at rear in mounting areas (5.3.6 (a) (i))

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Suspension arm ball joint dust cover deteriorated, but preventing the ingress of dirt Rear arm (2.4.G.2)

Nearside Front Suspension arm ball joint dust cover deteriorated, but preventing the ingress of dirt Rear arm (2.4.G.2)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Front Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

both rear tyres worn 3mm/perishing

front brake discs corroded/very poor condition inner surface

rear exhaust bracket broken

both front brake discs in poor condition inner surface

offside front/nearside rear tyres on 2/3mm 205/55/16 91w

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)