2008 Fiat Panda

Nearside Shock absorbers has a serious fluid leak (5.3.2 (b))

Exhaust mounting defective (6.1.2 (a))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Nearside Rear Shock absorbers has an excessively worn bush (5.3.2 (c))

Offside Rear Shock absorbers has a serious fluid leak (5.3.2 (b))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Shock absorbers has a slightly worn bush (5.3.2 (c))

Offside Rear Shock absorbers has light misting of oil (5.3.2 (b))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

recommend attention to nearside rear service and parking brake

Nearside Rear Shock absorbers has a slightly worn bush (5.3.2 (c))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Oil leak, but not excessive (8.4.1 (a) (i))

Offside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Nearside Rear Upper Shock absorber has a slightly worn bush (2.7.4)

Offside Rear Upper Shock absorber has an excessively worn bush (2.7.4)

Nearside Rear Upper Shock absorber has a slightly worn bush (2.7.4)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Nearside Rear Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

both rear tyres low tread.

exhaust back box corroded.

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)