2007 Dodge Caliber

Coil spring not correctly located n/s/f coil spring inadequately located (2.4.C.2)

Suspension arm has excessive play in a ball joint n/s/f ball joint (2.4.G.2)

Suspension arm has excessive play in a ball joint o/s/f ball joint (2.4.G.2)

Track rod end ball joint has excessive play n/s/f trackrod end (2.2.B.1f)

Tyre tread depth below requirements of 1.6mm n/s/r (4.1.E.1)

co just met minimum co%-heat shield insecure

exhaust slightly blowing-front discs wearing thin

front pads worn low-rack play

rear service and parking brake passed on limit-exhaust and mountings corroded

Brake pad(s) wearing thin (3.5.1g)

N/S/Front shock lower spring seat deformed

Nail in offside rear tyre

Nearside Drag link end ball joint has slight play (2.2.B.1f)

O/S/Rear tyre worn on inner edge

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Oil leak

Tyre pressure monitoring system warning lamp does not illuminate (4.1.D.4)

Vehicle presented in wet conditions

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Both front tyres worn on inner edges

Brake pad(s) wearing thin (3.5.1g)

Brake pad(s) wearing thin (3.5.1g)

N/S/Front shock lower spring seat deformed

Nail in offside rear tyre

Nearside Drag link end ball joint has slight play (2.2.B.1f)

O/S/Rear tyre worn on inner edge

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Oil leak

Tyre pressure monitoring system warning lamp does not illuminate (4.1.D.4)

Tyre worn close to the legal limit (4.1.E.1)

Vehicle presented in wet conditions

Fuel cap/sealing device does not fasten securely by positive means (7.2.4b)

Fuel cap/sealing device does not fasten securely maintaining the sealing arrangement (7.2.4b)

Hydraulic brake cylinder leaking hydraulic fluid (3.6.A.1)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Front Suspension arm has excessive play in a ball joint (2.4.G.2)

Offside Front Wheel nut(s) missing (4.2.A.1e)

Windscreen washer provides insufficient washer liquid (8.2.3)

Engine management light is on

Exhaust corroded

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Track rod end ball joint dust cover damaged, but preventing the ingress of dirt (2.2.C.1c)

Nearside and offside front tyres wearing unevenly

Nearside front tyre cracking on side walls

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Registration plate lamp not working (1.1.C.1d)

Rear Brake pad(s) wearing thin (3.5.1g)

Tyre pressure monitoring light flashing

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Brake pad(s) wearing thin (3.5.1g)

Suspension arm rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front position lamp(s) not working (1.1.A.3b)

Shock absorber has a serious fluid leak (2.7.3)

Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Brake pad(s) wearing thin (3.5.1g)

Suspension arm rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Front registration plate deteriorated (6.3.1d)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Front Suspension arm has excessive play in a ball joint (2.4.G.2)