2005 Audi A3

Manufactures engine and body covers fitted restricting full inspection

Nearside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Nearside Front Coil spring corroded (5.3.1 (b) (i))

Nearside Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Nearside Outer sill damaged

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Supplementary restraint system warning lamp does not illuminate (7.1.6 (a))

Suspension arm pin or bush worn but not resulting in excessive movement both front lower arm rear bushes (5.3.4 (a) (i))

offside front bumper slightly insecure offside front under tray broken but still secure

rear exhaust heat shields slightly insecure

windscreen washers working but slightly weak

Advise dirty underneath

Engine light on

Nearside Front All direction indicators slightly discoloured Side repeater (4.4.3 (a))

Nearside Front Anti-roll bar ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Front Coil spring corroded (5.3.1 (b) (i))

Nearside Front Coil spring worn (5.3.1 (b) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front All direction indicators slightly discoloured (4.4.3 (a))

Offside Front All direction indicators slightly discoloured Side repeater (4.4.3 (a))

Offside Front Anti-roll bar ball joint has slight play (5.3.4 (a) (i))

Offside Front Fog lamp not working

Rear Both rear back plates corroded

Rear Brake lining(s) wearing thin (1.1.13 (a) (ii))

Rear Discs corroded

Supplementary restraint system warning lamp does not illuminate Has been covered (7.1.6 (a))

Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Manufactures under trays fitted restricting inspection of components

Nearside Front Inner Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Inner Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

All standard equipment guards fitted at time of test not allowing full inspection

Nearside Front suspension has slight movement at a wishbone pin or bush (2.5.A.1c)

Offside Front suspension has slight movement at a wishbone pin or bush (2.5.A.1c)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Manufactures under trays fitted restricting inspection of components

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Nail in nearside rear tyre

Sidewall damage to nearside front tyre

Uneven wear inner edge of nearside rear tyre

Engine covers fitted obscuring some components in the engine bay

Nail in nearside rear tyre

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Under-trays fitted obscuring some underside components

both front lower arm inner rear bushes starting to split

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside rear brake binding (3.7.B.1)

Engine covers fitted obscuring some components in the engine bay

Nail in nearside rear tyre

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Headlamp aim too high (1.8)

Under-trays fitted obscuring some underside components

both front lower arm inner rear bushes starting to split

Engine covers fitted obscuring some components in the engine bay

Under-trays fitted obscuring some underside components

rear tyres slighlt misshappen

small chips in windscreen

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Rear Brake pad(s) wearing thin (3.5.1g)

nearside front tyre wearing down on inner edge

Offside Rear Tyre has a lump, caused by separation or partial failure of its structure (4.1.D.1b)