2005 Hyundai Matrix

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Brake performance unable to be tested due to fluid leak no brake pedal (1.2.1 (g))

Nearside Rear Brake pipe excessively corroded leaking (1.1.11 (c))

Offside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Front discs rusty

Nearside Headlamp lens slightly defective (4.1.1 (b) (i))

Offside Headlamp lens slightly defective (4.1.1 (b) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Front Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material recomend replace (1.1.11 (c))

Nearside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Front Service brake excessively binding (1.2.1 (f))

Front Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material recomend replace (1.1.11 (c))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Power steering component has slight seepage from a component pipes above rack (2.1.5 (a))

Front Exhaust has a major leak of exhaust gases flexi (6.1.2 (a))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Front Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Headlamp aim too high (4.1.2 (a))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill outer (5.3.6 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Power steering component has slight seepage from a component pipes above rack (2.1.5 (a))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Offside Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Front Service brake excessively binding (1.2.1 (f))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

center rear seat belt slow to recoil

slight power steering oil leak

Nearside Front Shock absorber has a light misting of oil (2.7.3)

Power steering fluid level low, but not below minimum (2.3.1)

Power steering pipe(s) or hose(s) has slight seepage from a joint (2.3.3b)

Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Front Shock absorber has a light misting of oil (2.7.3)

Power steering fluid level low, but not below minimum (2.3.1)

Power steering pipe(s) or hose(s) has slight seepage from a joint (2.3.3b)

Nearside Front Shock absorber has a light misting of oil (2.7.3)

Centre Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front Headlamp aim too low (1.8)

Offside Front Headlamp aim beam image obviously incorrect (1.8.A.1b)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Power steering pipe(s) or hose(s) has slight seepage (2.3.3b)

both front tyres bold on edges

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Power steering pipe(s) or hose(s) has slight seepage (2.3.3b)

both front tyres bold on edges

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Front tyres low on edges,2.5mm approx.