2006 Mazda 3

front spot light not working

side repeater lenses missing

both rear roll bar links

Headlamp light intensity severely reduced both front lenses (4.1.4 (a))

Nearside Front Headlamp light intensity severely reduced no pattern (4.1.4 (a))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Nearside Front Tyre tread depth below requirements of 1.6mm inner edge (5.2.3 (e)) DANGEROUS

both rear roll bar links

front spot light not working

side repeater lenses missing

Nearside Front Inner Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Lower Suspension arm ball joint has slight play (5.3.4 (a) (i))

Offside Front Shock absorbers has light misting of oil (5.3.2 (b))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Car undersealed

Car undersealed

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Front Anti-roll bar corroded but not seriously weakened and rear (5.3.3 (b) (i))

Front Inner Integral body structure is corroded but structural rigidity is not significantly reduced rear inner bothside (6.1.1 (c) (i))

Nearside Front Inner Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Front Inner Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Offside Front Suspension arm ball joint has slight play (5.3.4 (a) (i))

Offside Rear Axle swivel pins and bushes swivel pin and/or bush slightly worn (5.1.2 (b) (i))

Offside Rear Outer Tyre has a cut but not deep enough to reach the ply or cords (5.2.3 (d) (i))

Rear Exhaust mounting defective (6.1.2 (a))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear Suspension arm corroded but not seriously weakened bothside (5.3.3 (b) (i))

Rear Suspension rod corroded but not seriously weakened bothside all (5.3.3 (b) (i))

Rear Suspension rod pin or bush worn but not resulting in excessive movement bothside all (5.3.4 (a) (i))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Front Windscreen washer provides insufficient washer liquid bothside (3.5 (a))

Nearside Front Shock absorbers has a serious fluid leak (5.3.2 (b))

Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Front Anti-roll bar corroded but not seriously weakened and rear (5.3.3 (b) (i))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Inner Integral body structure is corroded but structural rigidity is not significantly reduced rear inner bothside (6.1.1 (c) (i))

Nearside Front Inner Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Front Inner Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Offside Front Suspension arm ball joint has slight play (5.3.4 (a) (i))

Offside Rear Axle swivel pins and bushes swivel pin and/or bush slightly worn (5.1.2 (b) (i))

Offside Rear Outer Tyre has a cut but not deep enough to reach the ply or cords (5.2.3 (d) (i))

Rear Exhaust mounting defective (6.1.2 (a))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear Suspension arm corroded but not seriously weakened bothside (5.3.3 (b) (i))

Rear Suspension rod corroded but not seriously weakened bothside all (5.3.3 (b) (i))

Rear Suspension rod pin or bush worn but not resulting in excessive movement bothside all (5.3.4 (a) (i))

Front Inner Tyre worn close to legal limit/worn on edge both side (5.2.3 (e))

Rear Exhaust mounting defective (6.1.2 (a))

Anti-roll bar corroded but not seriously weakened Front and Rear (5.3.3 (b) (i))

Rear Lower Suspension arm corroded but not seriously weakened both sides (5.3.3 (b) (i))

Rear Lower Suspension arm pin or bush worn but not resulting in excessive movement both sides (5.3.4 (a) (i))

Rear Upper Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Anti-roll bar corroded but not seriously weakened Front and Rear (5.3.3 (b) (i))

Front Position lamp not working both sides (4.2.1 (a))

Rear Lower Suspension arm corroded but not seriously weakened both sides (5.3.3 (b) (i))

Rear Lower Suspension arm pin or bush worn but not resulting in excessive movement both sides (5.3.4 (a) (i))

Rear Upper Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Coolant leak ()

Front Brake pad(s) wearing thin (3.5.1g)

Front Brake pad(s) wearing thin (3.5.1g)

Offside Front Inner Tyre worn close to the legal limit (4.1.E.1)

Rear suspension components corroded

Headlamp cleaning device inoperative (1.7.2)

Nearside Windscreen washer provides insufficient washer liquid (8.2.3)

Registration plate lamp not working (1.1.C.1d)

Nearside Front Shock absorber has a light misting of oil (2.7.3)

Tie bar/rod corroded but not seriously weakened (2.4.G.1)

Rear suspension components slightly corroded

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Front Inner Tyre has ply or cords exposed (4.1.D.1b)

Nearside Front Inner Tyre worn close to the legal limit (4.1.E.1)

Rear suspension components slightly corroded

N/S/R Tyre wearing on inside edge

Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Front Lower Suspension arm has excessive play in a pin/bush (2.4.G.2)

Offside Front Lower Suspension arm has excessive play in a pin/bush (2.4.G.2)

Supplementary Restraint System warning lamp indicates a fault (5.4.2)

N/S/R Tyre wearing on inside edge

Rear Brake pad(s) wearing thin (3.5.1g)

Nail in offside rear tyre

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

both rear inner sill's starting to corrode

front brake disc's slight corrosion

offside front tyre inner edge wearing

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Front suspension has slight movement at a wishbone pin or bush (2.5.A.1c)

Nearside Rear Tyre has ply or cords exposed (4.1.D.1b)

Nearside Front suspension has slight movement at a wishbone pin or bush (2.5.A.1c)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

screw in osr tyre and small cut in sidewall

traction control light illuminated