2006 Audi Tt

Both front lower suspension arm rear bushes are perished and worn

Both front lower suspension arm rear bushes are perished and worn

Nearside Front Headlamp aim too low (4.1.2 (a))

Offside Front Headlamp aim too low (4.1.2 (a))

Nearside Front Headlamp lens slightly defective (4.1.1 (b) (i))

Offside Front Headlamp lens slightly defective (4.1.1 (b) (i))

Nearside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Rear Service brake excessively binding (1.2.1 (f))

Nearside Headlamp lens slightly defective (4.1.1 (b) (i))

Offside Headlamp lens slightly defective (4.1.1 (b) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Upper top mounting has slight play

Nearside Rear Brake pipe corroded, covered in grease or other material front to rear pipe (1.1.11 (c))

Offside Front Tyre worn close to legal limit/worn on edge inside edge (5.2.3 (e))

Offside Rear Coil spring fractured or broken (5.3.1 (b) (i))

Nearside Front Upper top mounting has slight play

Nearside Rear Brake pipe corroded, covered in grease or other material front to rear pipe (1.1.11 (c))

Offside Front Tyre worn close to legal limit/worn on edge inside edge (5.2.3 (e))

Front Macpherson strut has slight movement at the upper attachment both (2.5.A.1c)

Nearside Rear Brake hose has slight corrosion to ferrules (3.6.B.4e)

Rear coil spring corroded both (2.4.C.1b)

Suspension component mounting prescribed area is corroded but not considered excessive both rear axle beam mounting points (2.4.A.3)

axle beam corroding

Exhaust system not adequately supported centre (7.1.1)

Rear Mechanical brake component has restricted free movement both (3.5.1k)

Rear brake disc in such a condition that it is seriously weakened both (3.5.1i)

Front Macpherson strut has slight movement at the upper attachment both (2.5.A.1c)

Nearside Rear Brake hose has slight corrosion to ferrules (3.6.B.4e)

Rear coil spring corroded both (2.4.C.1b)

Suspension component mounting prescribed area is corroded but not considered excessive both rear axle beam mounting points (2.4.A.3)

axle beam corroding

Offside Front Suspension arm rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

Offside Front position lamp(s) not working (1.1.A.3b)

Nearside Front Suspension arm rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Registration plate lamp not working (1.1.C.1d)