2004 Isuzu Rodeo

Brake hose has slight corrosion to ferrule both front flexi hose steel sections corroded (1.1.12 (f) (i))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Oil leak, but not excessive rear crank seal and oil filter is corroding off (8.4.1 (a) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced all rear of chassis corroded from rear axle back (6.1.1 (c) (i))

front caliper sliders very worn

outside of body wheelarches corroded through, and taped over sharp edges

rear light lenses all cracked

Offside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Offside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Oil leak, but not excessive rear crank seal and oil filter is corroding off (8.4.1 (a) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced all rear of chassis corroded from rear axle back (6.1.1 (c) (i))

front caliper sliders very worn

outside of body wheelarches corroded through, and taped over sharp edges

rear light lenses all cracked

both rear bump stops missing and rear chassis crossmember corroded

offside rear light lens broken, not affecting light output

wheel arches corroded and taped over

Front Brakes imbalanced across an axle 34% out of balance offside front binding (1.2.1 (b) (i))

Offside Front Service brake excessively binding (1.2.1 (f))

Rear Registration plate lamp likely to become detached (4.7.1 (c) (ii))

Rear fog lamp not working (4.5.1 (a) (ii))

both rear bump stops missing and rear chassis crossmember corroded

offside rear light lens broken, not affecting light output

wheel arches corroded and taped over

Nearside Front Wheel bearing has slight play (5.1.3 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Suspension component mounting prescribed area is corroded but not considered excessive all front and rear components (5.3.6 (a) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced vehicle underbody. (6.1.1 (c) (i))

Brake pipe excessively corroded 2 x across rear axle (1.1.11 (c))

Offside Registration plate lamp does not illuminate simultaneously with the position lamps (4.7.2 (a))

Anti-roll bar linkage ball joint likely to become detached both front arb linkages worn (5.3.4 (a) (ii)) DANGEROUS

Nearside Front Wheel bearing has slight play (5.1.3 (a) (i))

Offside Registration plate lamp insecure bulb holder swinging in the breeze (4.7.1 (c) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Suspension component mounting prescribed area is corroded but not considered excessive all front and rear components (5.3.6 (a) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced vehicle underbody. (6.1.1 (c) (i))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside Rear Position lamp has a product on the lens or light source but not adversely affecting light intensity (4.2.3 (b) (ii))

Offside Rear Position lamp has a product on the lens or light source but not adversely affecting light intensity (4.2.3 (b) (ii))

Offside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Exhaust has a major leak of exhaust gases (6.1.2 (a))

Nearside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Nearside Rear Tyre has a lump, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Offside Rear Tyre has a lump, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside Rear Position lamp has a product on the lens or light source but not adversely affecting light intensity (4.2.3 (b) (ii))

Offside Rear Position lamp has a product on the lens or light source but not adversely affecting light intensity (4.2.3 (b) (ii))

Offside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

General underbody corrosion

Front Windscreen washer provides insufficient washer liquid (3.5 (a))

Nearside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Front Lower Suspension arm ball joint excessively worn As marked (5.3.4 (a) (i))

Brake pedal travel longer than expected

Front Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

General underbody corrosion

Front registration plate deteriorated but not likely to be misread (6.3.1d)

Offside Front Front wheel bearing has slight play (2.5.A.3c)

both rear light clusters cracked

Brake pipe excessively corroded front to rear brake pipe (3.6.B.2c)

Offside Registration plate lamp not working (1.1.C.1d)

Front registration plate deteriorated but not likely to be misread (6.3.1d)

Offside Front Front wheel bearing has slight play (2.5.A.3c)

both rear light clusters cracked

Brake pipe slightly corroded Front to rear at back axle (3.6.B.2c)

Front registration plate deteriorated but not likely to be misread (6.3.1d)

Nearside Front Lower Suspension arm ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Front Brakes imbalanced across an axle (3.7.B.5b)

Rear Brakes imbalanced across an axle (3.7.B.5b)

Front registration plate deteriorated but not likely to be misread (6.3.1d)

Nearside Front Lower Suspension arm ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Nearside Front wheel bearing has slight play (2.5.A.3c)

Offside Front wheel bearing has slight play (2.5.A.3c)

Front registration plate deteriorated but not likely to be misread (6.3.1d)

Offside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside front brake binding (3.7.B.1)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Registration plate lamp not working (1.1.C.1d)

Front registration plate deteriorated but not likely to be misread (6.3.1d)

Offside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Parking brake lever has little reserve travel (3.1.6b)

Exhaust emits excessive smoke or vapour of any colour (7.4.B.4)

Brake pipe slightly corroded (3.6.B.2c)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Parking brake lever has little reserve travel (3.1.6b)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Brakes imbalanced across an axle (3.7.B.5b)

Exhaust emits an excessive level of metered smoke for a turbo charged engine (7.4.B.3b)

Nearside Stop lamp not working (1.2.1b)

Nearside Front Upper brake caliper securing device missing (3.5.1j) DANGEROUS

Offside Front Upper brake caliper securing device loose (3.5.1j) DANGEROUS

Front Brake pad(s) wearing thin (3.5.1g)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Nearside front brake binding (3.7.B.1)

Offside front brake binding (3.7.B.1)

Rear fog lamp not working (1.3.2b)

Nearside Headlamp aim too high (1.8)

Offside Headlamp aim too high (1.8)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)