2003 Mazda 323

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Headlamp has a product on the lens but not seriously reducing light output both sides (4.1.4 (b))

Lower Integral body structure is repaired but structural rigidity is not significantly reduced both outer sills (6.1.1 (d) (i))

Nearside Rear Stop lamp(s) slightly affected by the operation of another lamp (4.3.3 (b))

Rear Vehicle structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security and also covered in under seal (6.2.2 (d) (i))

Offside Rear Lower Vehicle structure has excessive corrosion which adversely affects braking or steering (6.1.1 (c) (ii)) DANGEROUS

Front Headlamp lens slightly defective both side (4.1.1 (b) (i))

Nearside Front Lower Vehicle structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Front Headlamp has a product on the lens but not seriously reducing light output both side (4.1.4 (b))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Rear Vehicle structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

OBD NOT READING ECU

Offside Rear Parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (1.4.2 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Vehicle structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Vehicle structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security Both rear inner seal (6.2.2 (d) (i))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Vehicle structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security Both rear inner seal (6.2.2 (d) (i))

Both inner seals (near the rear wheel arch) has corrosion but not gone through.

Both inner seals (near the rear wheel arch) has corrosion but not gone through.

Nearside Headlamp aim too high (4.1.2 (a))

General corrosion at prescribed area + suspension components

Offside Front front brake binding (3.7.B.1)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)