2005 Mazda 3

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside Front Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Front Suspension arm ball joint has slight play (5.3.4 (a) (i))

Offside Front Vehicle structure is corroded but structural rigidity is not significantly reduced Lower wing. (6.1.1 (c) (i))

Offside Rear Registration plate lamp insecure (4.7.1 (c) (i))

Headlamp levelling device cannot be operated from the driver's seat Offside front headlamp. (4.1.5 (b))

Nearside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Front Headlamp aim too low (4.1.2 (a))

Offside Side repeater not working (4.4.1 (a) (ii))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside Front Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Front Suspension arm ball joint has slight play (5.3.4 (a) (i))

Offside Front Vehicle structure is corroded but structural rigidity is not significantly reduced Lower wing. (6.1.1 (c) (i))

Offside Rear Registration plate lamp insecure (4.7.1 (c) (i))

Nearside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge 2mm and worn on inner edge (5.2.3 (e))

Rear Lower Suspension arm corroded but not seriously weakened both (5.3.3 (b) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Windscreen damaged but not adversely affecting driver's view minor damage (3.2 (a) (i))

Front Headlamp lens slightly defective both sides (4.1.1 (b) (i))

Nearside Front slight worn on inner edge

Offside Front Tyre worn close to legal limit/worn on edge worn on inner edge (5.2.3 (e))

under side slight rusty

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill end (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill end (5.3.6 (a) (i))

Front Headlamp lens slightly defective both sides (4.1.1 (b) (i))

Nearside Front slight worn on inner edge

Offside Front Tyre worn close to legal limit/worn on edge worn on inner edge (5.2.3 (e))

under side slight rusty

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))

Offside Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Nearside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))

Offside Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Position lamp with a multiple light source more than 1/2 not functioning (4.2.1 (a) (ii))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement wishbone rear bush (5.3.4 (a) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement wishbone rear bush (5.3.4 (a) (i))

Offside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Rear Coil spring fractured or broken (5.3.1 (b) (i))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement wishbone rear bush (5.3.4 (a) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement wishbone rear bush (5.3.4 (a) (i))

Front Brake pad(s) wearing thin *strong advise* (3.5.1g)

Nearside Front Anti-roll bar linkage ball joint dust cover damaged, but preventing the ingress of dirt (2.4.G.2)

Nearside Front Valve stem slightly damaged (4.1.D.1e)

Nearside Rear coil spring corroded (2.4.C.1b)

Offside Front Anti-roll bar linkage ball joint dust cover damaged, but preventing the ingress of dirt (2.4.G.2)

Offside Front Valve stem slightly damaged (4.1.D.1e)

Offside Front coil spring corroded at top (2.4.C.1b)

Suspension component mounting prescribed area is corroded but not considered excessive both rear inner sills (2.4.A.3)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

offside rear tyre starting to perrish

o/s/r tyre has cracking in tread