2006 Mazda 3

Front Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt both sides (5.3.4 (b) (ii))

Service brake efficiency below requirements (1.2.2 (a) (i))

Front Tyre tread depth below requirements of 1.6mm both sides (5.2.3 (e)) DANGEROUS

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive both sides inner sill (5.3.6 (a) (i))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Offside Rear Anti-roll bar ball joint has slight play (5.3.4 (a) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

both sides inner sills corroded

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

both side inner sill corroded

Offside Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Nearside Rear Nail in tyre ()

Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Nearside Parking brake inoperative on one side (1.4.1 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Nearside Front Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Offside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Front Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Exhaust mounting defective Exhaust Bracket Rusted Off But Not Likely To Make The Exhaust System Dangerous (6.1.2 (a))

Nearside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Registration plate lamp not working (1.1.C.1d)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)