2005 Mazda 3

Central Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Headlamp lens slightly defective both (4.1.1 (b) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

various under body surface rust

Nearside Seat belt anchorage prescribed area strength or continuity significantly reduced (7.1.1 (a) (i))

Nearside Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill (5.3.6 (a) (i))

Nearside Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Offside Seat belt anchorage prescribed area strength or continuity significantly reduced (7.1.1 (a) (i))

Offside Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill (5.3.6 (a) (i))

Nearside Front Windscreen wiper blade defective (3.4 (b) (i))

Offside Front Windscreen wiper blade defective (3.4 (b) (i))

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Rear Seat belt anchorage prescribed area is corroded but not considered excessive (7.1.1 (a) (i))

Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Rear Brake disc worn, but not excessively (1.1.14 (a) (i))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive inner sill (5.3.6 (a) (i))

under body covered in thick under seal

Nearside Front Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Front Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Rear Exhaust silencer slightly loose (8.1.1 (b) (i))

genarel rusty under body

Emissions not tested (8.2.1.2 (d))

Exhaust has a major leak of exhaust gases (6.1.2 (a))

Nearside Rear Shock absorbers has negligible damping effect (5.3.2 (d))

Offside Front Seat belt anchorage prescribed area strength or continuity significantly reduced floor by chassis (7.1.1 (a) (i))

Offside Stop lamp(s) not working (4.3.1 (a) (ii))

Nearside Front Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Front Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Rear Exhaust silencer slightly loose (8.1.1 (b) (i))

genarel rusty under body

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive FLOOR (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive INNER SILL (5.3.6 (a) (i))

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive FLOOR (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive INNER SILL (5.3.6 (a) (i))

Brake disc worn, pitted or scored, but not seriously weakened all 4 (1.1.14 (a) (ii))

Front Suspension arm pin or bush worn but not resulting in excessive movement nearside front offside front rear wishbone bushes (5.3.4 (a) (i))

exhaust heat sheild insecure

underbody severly corroded but no holes

Front Suspension arm pin or bush excessively worn near side front and off side front rear wishbone bushes (5.3.4 (a) (i))

Nearside Front Outer Body panel corroded and likely to cause injury wheel arch corroded and very sharp edges (6.2.1 (a) (i))

Offside Front Outer Body panel corroded and likely to cause injury wheel arch corroded and very sharp edges (6.2.1 (a) (i))

Offside Front Position lamp not working (4.2.1 (a))

Rear Exhaust silencer insecure (8.1.1 (b) (i))

Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Front Brake disc worn, pitted or scored, but not seriously weakened both front (1.1.14 (a) (ii))

Front Headlamp lens slightly defective both front (4.1.1 (b) (i))

Rear Brake disc worn, pitted or scored, but not seriously weakened both rear (1.1.14 (a) (ii))

Rear Near side rear off side rear inner wheel arch covers insecure

exhaust heat sheild insecure

underbody severly corroded but no holes

Nearside Front Inner Suspension arm pin or bush excessively worn Rear bush (5.3.4 (a) (i))

Nearside Position lamp not working (4.2.1 (a))

Nearside Rear reflector missing (4.8.2 (a) (ii))

Rear Brake disc worn, pitted or scored, but not seriously weakened Corroded (1.1.14 (a) (ii))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Tyre worn close to the legal limit 2-3mm (4.1.E.1)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Front Shock absorber has a serious fluid leak (2.7.3)

Nearside Rear Shock absorber has a serious fluid leak (2.7.3)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)