2004 Isuzu Rodeo

Offside Front Vehicle structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security unable to fully inspect due to thick coating (6.2.2 (d) (i))

Nearside Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced chassis rail (6.1.1 (c) (i))

Offside Front Vehicle structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security unable to fully inspect due to thick coating (6.2.2 (d) (i))

Offside Front body mount area corroded

Offside Rear Leaf spring has slight wear in a shackle pin and/or bush (5.3.4 (a) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

both rear suspension bump stops missing

rear load area corroded around body mountings

tow bar corroded

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength chassis near spring mount (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength front spring mount area on chassis (5.3.6 (a) (i))

Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Front body mount area corroded

Offside Rear Leaf spring has slight wear in a shackle pin and/or bush (5.3.4 (a) (i))

both rear suspension bump stops missing

rear load area corroded around body mountings

tow bar corroded

Offside Front body mount to chassis corroded

Offside Rear Leaf spring has slight wear in a shackle pin and/or bush (5.3.4 (a) (i))

Towbar component corroded, but not excessively (6.1.6 (a))

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

both rear bump stops missing

center rear stop light not working

rear body to chassis has corrosion around various mounts but still secure to vehicle

Nearside Rear Leaf spring shackle pin or bush excessively worn (5.3.4 (a) (i))

Nearside Rear Suspension spring mounting prescribed area excessively corroded significantly reducing structural strength inside of chassis (5.3.6 (a) (i))

Nearside Rear Suspension spring mounting prescribed area excessively corroded significantly reducing structural strength outside of chassis (5.3.6 (a) (i))

Offside Rear Suspension spring mounting prescribed area excessively corroded significantly reducing structural strength outside of chassis (5.3.6 (a) (i))

Offside Front body mount to chassis corroded

Offside Rear Leaf spring has slight wear in a shackle pin and/or bush (5.3.4 (a) (i))

Towbar component corroded, but not excessively (6.1.6 (a))

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

both rear bump stops missing

rear buck to chassis has corrosion around various mounts but still secure to vehicle

Nearside Front Lower Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

break test not carried out due to fluid leakage

Front Brake pipe excessively corroded both sides (1.1.11 (c))

Offside Stop lamp(s) emits other than a steady red light (4.3.3 (a) (ii))

Rear Brake pipe excessively corroded (1.1.11 (c))

Rear Exhaust has a major leak of exhaust gases (6.1.2 (a))

Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength both sides (5.3.6 (a) (i))

Spare wheel insecure in carrier (6.1.5 (b) (i))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Service brake efficiency less than 50% of the required value (1.2.2 (a) (ii)) DANGEROUS

Nearside Front Lower Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

break test not carried out due to fluid leakage

Emissions not tested (8.2.2.2 (e))

Front Exhaust has a major leak of exhaust gases Pipe (6.1.2 (a))

Nearside Front Lower Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Heavily undersealed

Offside Front Seat belt webbing slightly damaged or frayed (7.1.2 (b) (ii))

Offside Stop lamp(s) light intensity obviously reduced (4.3.3 (a) (i))

Rear Axle swivel pins and bushes swivel pin and/or bush slightly worn (5.1.2 (b) (i))

Rear Buck corroded

Spare wheel loose

Stop lamp(s) with a multiple light source up to 1/2 not functioning (4.3.1 (a) (i))

Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt Both sides (2.1.3 (g) (i))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Heavily undersealed

Rear Buck corroded

Rear Leaf spring has slight wear in a shackle pin and/or bush BOTH SIDES (5.3.4 (a) (i))

Front Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting BOTH SIDES (6.2.2 (d) (i))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Heavily undersealed

Rear Buck corroded

Rear Leaf spring has slight wear in a shackle pin and/or bush BOTH SIDES (5.3.4 (a) (i))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Heavily undersealed

Nearside Front Outer Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Buck corroded

Nearside Front Inner Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting Arch (6.2.2 (d) (i))

Nearside Front Upper Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Front Lower Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Heavily undersealed

Nearside Front Outer Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Buck corroded

Rear Tyre worn close to legal limit/worn on edge both (5.2.3 (e))

under side heavily under sealed

front and middle exhaust

Front Brake pad(s) wearing thin (3.5.1g)