2010 Ford S-max

Front Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

Front Service brake fluctuating, but not excessively (1.2.1 (e))

Offside Front Seat belt webbing slightly damaged or frayed (7.1.2 (b) (ii))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Power steering component has slight seepage from a component tank (2.1.5 (a))

Rear Anti-roll bar corroded but not seriously weakened (5.3.3 (b) (i))

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front Seat belt stitching slightly frayed passenger (5.2.2b)

Offside Front Play in steering rack inner joint(s) ()

Offside Front Seat belt stitching slightly frayed drivers (5.2.2b)

Oil leak ()

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Front Brake pad(s) wearing thin (3.5.1g)

Front Exhaust has a minor leak of exhaust gases (7.1.2)

Offside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Offside Front Seat belt stitching slightly frayed drivers (5.2.2b)

Offside Front Track rod end ball joint has slight play (2.2.B.1f)

Offside Rear Nail in tyre ()

Oil leak ()

Rear Tyre worn close to the legal limit wearing on inner edge (4.1.E.1)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Front Brake pad(s) wearing thin (3.5.1g)

oil leak

Brake hydraulic reservoir fluid close to minimum level (3.6.G.1b)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Headlamp aim too low (1.8)

Nearside Rear Trailing arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Headlamp aim too high (1.8)

cut in osf tyre tread

nsf tyre 3mm

Nearside Rear Trailing arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

cut in osf tyre tread

nsf tyre 3mm