2007 Chevrolet Matiz

Nearside Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced floor to sill. (6.1.1 (c) (i))

Nearside Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced sill. (6.1.1 (c) (i))

Offside Front Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced sill. (6.1.1 (c) (i))

Offside Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced sill end. (6.1.1 (c) (i))

Offside Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced sill. (6.1.1 (c) (i))

Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Front Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Offside Front Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Front Headlamp has a product on the lens but not seriously reducing light output Both sides (4.1.4 (b))

Front Outer Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt Both sides (2.1.3 (g) (i))

Front Suspension arm corroded but not seriously weakened Both sides (5.3.3 (b) (i))

Front Suspension component mounting prescribed area is corroded but not considered excessive Both sides (5.3.6 (a) (i))

Nearside Front Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive Both sides (5.3.6 (a) (i))

Front Headlamp has a product on the light source but not seriously reducing light output both side (4.1.4 (b))

Front Lower Suspension arm ball joint dust cover severely deteriorated both side (5.3.4 (b) (i))

Front Outer Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt both side (2.1.3 (g) (i))

front and rear suspension all around rusted

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Nearside Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i))

Offside Front Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Front Headlamp has a product on the light source but not seriously reducing light output both side (4.1.4 (b))

Front Lower Suspension arm ball joint dust cover severely deteriorated both side (5.3.4 (b) (i))

Front Outer Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt both side (2.1.3 (g) (i))

front and rear suspension all around rusted

Front Anti-roll bar pin or bush worn but not resulting in excessive movement both side (5.3.4 (a) (i))

Front Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt both side (2.1.3 (g) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge tyre perished (5.2.3 (e))

under vehicle lower structure and suspension components has slight corrosion all around

Front Windscreen washer provides insufficient washer liquid (3.5 (a))

Front passenger door cannot be opened from outside the vehicle (6.2.3 (a))

Nearside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Rear Passenger's seat backrest cannot be secured in the upright position. (6.2.6 (a) (i))

Centre Front exhaust bracket corroded

Nearside Rear exhaust bracket corroded

Nearside Headlamp aim too low (1.8)

Nearside Headlamp not working on dipped beam (1.7.5a)

Offside Headlamp aim too low (1.8)