2006 Chevrolet Matiz

Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Rear Suspension component corroded but not seriously weakened (5.3.3 (b) (i))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Rear Suspension component corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Nearside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Brake performance not tested Due to front pads. (1.2.1 (g))

Nearside Front Brake disc significantly and obviously worn (1.1.14 (a) (i))

Offside Front Brake disc significantly and obviously worn (1.1.14 (a) (i))

Offside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Rear fog lamp not working (4.5.1 (a) (ii))

Front Brake pad(s) less than 1.5 mm thick Metal to metal. (1.1.13 (a) (ii)) DANGEROUS

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Nearside Front Brake pipe corroded, covered in grease or other material Brake pipe corroded going to flexi (1.1.11 (c))

Nearside Front Service brake binding but not excessively (1.2.1 (f))

Nearside Front Tyre worn close to legal limit/worn on edge 2mm 155/65/13 (5.2.3 (e))

Nearside Front Brake pipe corroded, covered in grease or other material Brake pipe corroded going to flexi (1.1.11 (c))

Nearside Front Service brake binding but not excessively (1.2.1 (f))

Nearside Front Tyre worn close to legal limit/worn on edge 2mm 155/65/13 (5.2.3 (e))

Offside Front Position lamp not working replaced bulb 501 (4.2.1 (a) (ii))

Nearside Rear Parking brake inoperative on one side (1.4.1 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Nearside Rear Service brake has no recorded effort at a wheel (1.2.1 (a) (ii)) DANGEROUS

Nearside Front Tyre slightly damaged (5.2.3 (d) (ii))

Nearside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Nearside Front position lamp(s) not working (1.1.A.3b)

Offside Headlamp not working on dipped beam (1.7.5a)

Nearside Front brake disc slightly pitted (3.5.1h)

Offside Front brake disc slightly pitted (3.5.1h)