2004 Honda CRF250

Rear Suspension pin, bush or joint worn but not resulting in excessive movement (5.3.4 (a) (i))

Drive chain lightly rubbing (6.2.1d)

Lower Rear suspension bush has slight free play (2.4.A2a(i))

Steering movement slightly 'notchy' (2.2.1a)

Rear position lamp does not illuminate immediately when it is switched on (1.1.3a)

Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Drive chain lightly rubbing (6.2.1d)

Lower Rear suspension bush has slight free play (2.4.A2a(i))

Steering movement slightly 'notchy' (2.2.1a)

Chain guard missing

Front Tyre worn close to the legal limit (4.1.3(ii))

Nearside Front shock absorber has light misting of stanchion (2.3.3)

Front Tyre worn close to the legal limit (4.1.3(ii))

Nearside Front Front shock absorber has light misting of stanchion (2.3.3)

Offside Front Front shock absorber has light misting of stanchion (2.3.3)

Rear Rear shock absorber has a light misting (2.4.A.1c)

Rear Tyre worn close to the legal limit (4.1.3(ii))

Front Brake pad(s) close to minimum limit (3.2.A1f(i))

Front Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Nearside Front Handlebar handgrip not secure to handlebars. (2.1.1c)

Offside Front Handlebar handgrip not secure to handlebars. (2.1.1c)

Rear Brake pad(s) less than 1.5 mm thick (3.2.A1f(i))

Rear Brake pedal is inoperative (3.1.3c)

Rear Drive chain sprocket worn to excess (6.2.1e)

Rear Drive chain worn to excess (6.2.1e)

Rear Rear position lamp does not illuminate immediately when it is switched on (1.1.3a)

Rear Registration plate font not substantially similar to the prescribed font (6.3.4d)

Rear Registration plate margin less than the minimum requirement (6.3.4g)

Rear Registration plate with character(s) which are not of equal width along their entire length (6.3.4a)

Rear Registration plate with character(s) which are not the correct height (6.3.4a)

Rear Registration plate with character(s) which are not the correct width (6.3.4a)

Rear Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Roller brake test The less effective brake control does not achieve an efficiency of 25%. (3.3.A2b)

Front Brake pad(s) close to minimum limit (3.2.A1f(i))

Rear Roller brake test Higher brake efficiency normally obtainable. (3.3.A2b)

Rear reflector on motorcycle missing (1.4.1)

Front Tyre is unsuitable (4.1.1)

Rear Tyre is unsuitable (4.1.1)

Rear Wheel spoke excessively loose (4.2.1b)