2005 Fiat Panda

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Front Brake disc significantly and obviously worn (1.1.14 (a) (i))

Nearside Front Shock absorbers has a serious fluid leak (5.3.2 (b))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

front brake discs corroded

rear coil springs corroded

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust emissions likely to be affected by an exhaust leak (8.2.1.1 (b))

Front Exhaust has a major leak of exhaust gases flexi joint (6.1.2 (a))

Nearside Front Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Nearside Front Shock absorbers has a serious fluid leak (5.3.2 (b))

Nearside Parking brake inoperative on one side (1.4.1 (a))

Offside Front Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Front Service brake excessively binding (1.2.1 (f))

Offside Parking brake inoperative on one side (1.4.1 (a))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

front brake discs corroded

rear coil springs corroded

Brake pedal has insufficient reserve travel (1.1.2 (a))

Nearside Parking (secondary brake) on a single line braking system has inadequate effort at a wheel (1.3.1 (a) (i))

Nearside Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Offside Parking (secondary brake) on a single line braking system has inadequate effort at a wheel (1.3.1 (a) (i))

Offside Parking brake inoperative on one side (1.4.1 (a))

Offside Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Offside Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Offside Front Macpherson strut corroded but not seriously weakened (5.3.3 (b) (i))

Front NSF & OSF shock absorber casings corroding

Nearside Rear Service brake fluctuating, but not excessively (1.2.1 (e))

Rear Exhaust has a minor leak of exhaust gases silencer (6.1.2 (a))

Nearside Front Shock absorber has slight corrosion to the casing (2.7.2a)

Offside Front Shock absorber has slight corrosion to the casing (2.7.2a)

Oil leak ()

underbody corrosion

Offside Rear Outer Suspension component mounting prescribed area is excessively corroded sill (2.4.A.3)

Nearside Front Shock absorber has slight corrosion to the casing (2.7.2a)

Offside Front Shock absorber has slight corrosion to the casing (2.7.2a)

Oil leak ()

underbody corrosion

Oil leak ()

Parking brake lever has little reserve travel (3.1.6b)

handbrake efficiency on minimum requirement. attention required

wipers splitting on ends

oil leak

Nearside Front Anti-roll bar ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Front Anti-roll bar ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

oil leak

Front Lower Ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.2.C.1c)

Front Lower Ball joint has excessive play (2.2.B.1f)

Nearside Front Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Offside Front Anti-roll bar linkage ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Rear exhaust box outter skin corroded

rear exhaust box deterioated but not blowing

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Front brake disc in such a condition that it is seriously weakened (3.5.1i)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

rear exhaust box deterioated but not blowing

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Front discs worn/corroded

Offside Rear Shock absorber has a light misting of oil (2.7.3)

Rear Exhaust has part of the system slightly deteriorated (7.1.1a)

Rear Shock absorber has a light misting of oil (2.7.3)

Nearside Rear Shock absorber has a light misting of oil (2.7.3)

Offside Front Shock absorber has a light misting of oil (2.7.3)

Offside Rear Shock absorber has a light misting of oil (2.7.3)

Rear Exhaust has part of the system slightly deteriorated (7.1.1a)

exhaust mid section to rear securing clamp missing

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear Shock absorber has a light misting of oil (2.7.3)

Offside Front Shock absorber has a light misting of oil (2.7.3)

Offside Rear Shock absorber has a light misting of oil (2.7.3)

Rear Exhaust has part of the system slightly deteriorated (7.1.1a)

exhaust mid section to rear securing clamp missing