2010 Kia Sorento

Cab or chassis corroded within 30cm of a mounting, but not seriously affecting overall security both sills (6.2.2 (d) (i))

Nearside Front Shock absorbers has light misting of oil (5.3.2 (b))

Nearside Front Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Offside Front Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Brake pipe corroded, covered in grease or other material both main (1.1.11 (c))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Inner Vehicle structure is corroded but structural rigidity is not significantly reduced sills (6.1.1 (c) (i))

Front Lower Suspension arm corroded but not seriously weakened both (5.3.3 (b) (i))

Front Suspension arm pin or bush worn but not resulting in excessive movement both (5.3.4 (a) (i))

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Coil spring corroded both (5.3.1 (b) (i))

Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive sills (5.3.6 (a) (i))

Rear Sub-frame corroded but not seriously weakened and undersealed (5.3.3 (b) (i))

Rear Upper Suspension arm corroded but not seriously weakened both (5.3.3 (b) (i))

sill covers fitted

Nearside Front Brake disc worn, but not excessively (1.1.14 (a) (i))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Brake disc worn, but not excessively (1.1.14 (a) (i))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Suspension component mounting prescribed area is corroded but not considered excessive both rear inner sills (5.3.6 (a) (i))

rear axle and suspension corroded

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Windscreen wiper blade defective (3.4 (b) (i))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Rear Brake hose has slight corrosion to ferrules (3.6.B.4e)

Offside Rear Brake hose has slight corrosion to ferrules (3.6.B.4e)

Nearside Headlamp aim too low (1.8)

Offside Inner Headlamp aim too low (1.8)

Offside Side repeater not working (1.4.A.2c)

Parking brake lever has no reserve travel (3.1.6b)

Parking brake: efficiency below requirements (3.7.C.1b)

Offside Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Front Brake pad(s) wearing thin (3.5.1g)

Offside Side repeater not working (1.4.A.2c)

Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Front Brake pad(s) wearing thin (3.5.1g)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Under-trays fitted obscuring some underside components

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

rear nearside tyre craking poor condition

rear offside tyre cracking poor condition worn inside edge