2008 Ford Ka

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Exhaust carbon monoxide content at idle exceeds manufacturer's specified limits (8.2.1.2 (b))

Exhaust hydrocarbon content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Front Tyre fouling a part of the vehicle Inner wheel arch and power steering pipe both front tyres (5.2.3 (f))

Horn not working (7.7 (a))

Nearside Front Power steering pipe/hose excessively damaged chafed (2.1.5 (g) (i))

Nearside Headlamp aim too low (4.1.2 (a))

Nearside Rear Axle swivel pins and bushes swivel pin and/or bush excessively worn (5.1.2 (b) (i))

Nearside Rear Suspension component mounting prescribed area is inadequately repaired inner sill (5.3.6 (a) (i))

Nearside Seat belt anchorage prescribed area strength or continuity significantly reduced floor corroded (7.1.1 (a) (i))

Nearside Suspension component mounting prescribed area is inadequately repaired Floor /inner sill (5.3.6 (a) (i))

Offside Front Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Offside Headlamp aim too high (4.1.2 (a))

Offside Headlamp levelling device inoperative (4.1.5 (a))

Offside Rear Axle swivel pins and bushes swivel pin and/or bush excessively worn (5.1.2 (b) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill (5.3.6 (a) (i))

Offside Seat belt anchorage prescribed area strength or continuity significantly reduced floor corroded (7.1.1 (a) (i))

Windscreen washer provides insufficient washer liquid (3.5 (a))

Nearside Front Tyre has a bulge, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Brake hose slightly chafed (1.1.12 (b) (i))

Exhaust has a minor leak of exhaust gases Flexi pipe (6.1.2 (a))

Nearside Front Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Vehicle structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Nearside Rear Vehicle structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security metal plate welded/ used thumb pressure (6.2.2 (d) (i))

Offside Front Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced sill corroded (6.1.1 (c) (i))

Offside Rear Vehicle structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security sill (6.2.2 (d) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Sub-frame corroded but not seriously weakened axle (5.3.3 (b) (i))

Rear subframe/ springs /axle corroded

Suspension arm pin or bush worn but not resulting in excessive movement Both front rear bush (5.3.4 (a) (i))

Tyre worn close to legal limit/worn on edge Both front inner (5.2.3 (e))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

under seal sprayed on all vehicle under body

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Exhaust carbon monoxide content at idle exceeds default limits (8.2.1.2 (b))

Exhaust hydrocarbon content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Fuel hose damaged Corroded (6.1.3 (c) (ii))

Nearside Front Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Sil (5.3.6 (a) (i))

Nearside Front Macpherson strut top bush or bearing has excessive wear or free play (5.3.4 (a) (i))

Nearside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Sil (5.3.6 (a) (i))

Offside Front Macpherson strut top bush or bearing has excessive wear or free play (5.3.4 (a) (i))

Exhaust has a minor leak of exhaust gases Flexi pipe (6.1.2 (a))

Oil leak, but not excessive (8.4.1 (a) (i))

Suspension arm pin or bush worn but not resulting in excessive movement Both front rear bush (5.3.4 (a) (i))

Tyre worn close to legal limit/worn on edge Both front inner (5.2.3 (e))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Front Service brake binding but not excessively (1.2.1 (f))

Rear Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front structure corroded

Nearside Front Macpherson strut pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Axle swivel pins and bushes swivel pin and/or bush slightly worn (5.1.2 (b) (i))

Offside Front Macpherson strut pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Axle swivel pins and bushes swivel pin and/or bush slightly worn (5.1.2 (b) (i))

Offside Rear Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear structure corroded

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Horn not working (7.7 (a))

Nearside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Parking brake inoperative on one side (1.4.1 (a))

Offside Front Headlamp aim too high (4.1.2 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front structure corroded

Nearside Front Macpherson strut pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Axle swivel pins and bushes swivel pin and/or bush slightly worn (5.1.2 (b) (i))

Offside Front Macpherson strut pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Axle swivel pins and bushes swivel pin and/or bush slightly worn (5.1.2 (b) (i))

Offside Rear Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear structure corroded

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Oil leak, but not excessive (8.4.1 (a) (i))

Shock absorbers has light misting of oil offside front and nearside front (5.3.2 (b))

Suspension arm pin or bush worn but not resulting in excessive movement offside front and nearside front (5.3.4 (a) (i))

Suspension component mounting prescribed area is corroded but not considered excessive offside rear and nearside rear (5.3.6 (a) (i))

rear axle bushes deteriorated

Front Vehicle structure is corroded but structural rigidity is not significantly reduced rear (6.1.1 (c) (i))

underneath car corroded

Oil leak

Offside Front coil spring broken (2.4.C.1a)

Rear Exhaust system not adequately supported (7.1.1)

Oil leak

nearside front suspention arm rubber bush slightly unbonded

Nearside Suspension arm synthetic bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Suspension arm synthetic bush deteriorated but not resulting in excessive movement (2.4.G.2)