2009 Volkswagen Beetle

Nearside Front Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt starting to perish/split (2.1.3 (g) (i))

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Nearside Rear Shock absorbers has slight external damage to the casing corroded (5.3.2 (b))

Offside Front Sub-frame corroded but not seriously weakened central mounting point starting to corrode (5.3.3 (b) (i))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Offside Rear Shock absorbers has slight external damage to the casing corroded (5.3.2 (b))

Offside Rear Suspension arm pin or bush worn but not resulting in excessive movement lower suspension arm rear bush deteriorated and has play (5.3.4 (a) (i))

Nearside Front Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Nearside Rear Shock absorbers has slight external damage to the casing (5.3.2 (b))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Offside Rear Shock absorbers has slight external damage to the casing (5.3.2 (b))

Front Tyre worn close to legal limit/worn on edge Both (5.2.3 (e))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive Outer sill (5.3.6 (a) (i))

Offside Front Service brake fluctuating, but not excessively (1.2.1 (e))

Offside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Rear Position lamp not working Bulb fitted incorrectly ! (4.2.1 (a) (ii))

Offside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Rear Play in steering rack inner joint(s) ()

Offside Rear Play in steering rack inner joint(s) ()

Electronic stability control warning lamp indicates a fault (7.12 (e))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Offside Rear Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting (6.2.2 (d) (i))

Offside Front Wheel bearing so rough it is likely to overheat or break up (5.1.3 (b) (ii)) DANGEROUS

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Rear Play in steering rack inner joint(s) ()

Offside Rear Play in steering rack inner joint(s) ()

Offside Front Wheel bearing slightly noisy (5.1.3 (b) (i))

Offside Rear Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Play in steering rack inner joint(s) ()

Offside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Front Wheel bearing slightly noisy (5.1.3 (b) (i))

Offside Rear Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Play in steering rack inner joint(s) ()

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

engine bay and under covers fitted

rear tyres stepped and wearing low, n/s/r lower, close to legal limit

small hole and slight grease leak o/s outer cv boot

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Front Tyre worn close to the legal limit (2mm) and edges badly worn (4.1.E.1)

Offside Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

check tracking

front tyres worn low, close to legal limit, lower/bald inner edges and cracking in tread

rear tyres starting to crack in tread

has a thin slice of rubber loose on the nearside front tyre side wall, but not enough to see cords.

Nearside Windscreen wiper blade insecure (8.2.2)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

has a thin slice of rubber loose on the nearside front tyre side wall, but not enough to see cords.

off side hand brake leaver on caliper not fully returning