2006 Land Rover Range Rover

Central Rear Brake pipe excessively corroded (1.1.11 (c))

Nearside Lower Body insecure (6.2.2 (a) (i))

Nearside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Lower Body insecure to the extent that stability is seriously impaired sill (6.2.2 (a) (ii)) DANGEROUS

Nearside Front Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength suspension mounting (5.3.6 (a) (i))

Offside Front Suspension arm pin or bush excessively worn straight arm (5.3.4 (a) (i))

Offside Front Track rod end ball joint has excessive play (2.1.3 (b) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength suspension mounting (5.3.6 (a) (i))

Nearside Rear Inner Tyre has a tear, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Nearside Front Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Seat belt anchorage prescribed area is corroded but not considered excessive (7.1.1 (a) (i))

Nearside Front Suspension arm ball joint has slight play (5.3.4 (a) (i))

Rear Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Front Suspension arm ball joint has slight play (5.3.4 (a) (i))

Nearside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Rear Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Front Lower Suspension arm ball joint has slight play rear (5.3.4 (a) (i))

Offside Rear Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Front Lower Suspension arm ball joint has slight play (5.3.4 (a) (i))

parking brake only just met requirements

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Front Lower Suspension arm ball joint has slight play front arm (5.3.4 (a) (i))

Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Front registration plate character(s) incorrectly spaced (6.3.4a)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Nearside rear brake binding (3.7.B.1)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Rear registration plate character(s) incorrectly spaced (6.3.4a)

Registration plate lamp not working (1.1.C.1d)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

nearside rear tyre showing surface tears around side wall.

Front registration plate character(s) incorrectly spaced (6.3.4a)

Offside Front Lower Suspension arm has excessive play in a ball joint (2.4.G.2)

Rear registration plate character(s) incorrectly spaced (6.3.4a)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

nearside rear tyre showing surface tears around side wall.

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Outer Rear Lower Suspension arm has excessive play in a pin/bush (2.4.G.2)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)