1984 Mercedes Hymer

Oil leak, but not excessive (8.4.1 (a) (i))

Offside Front Seat belt not functioning as intended (7.1.2 (c))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Nearside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Rear Anti-roll bar pin or bush excessively worn d bush (5.3.4 (a) (i))

Offside Front Seat belt retracting mechanism defective (7.1.2 (e))

Offside Seat belt retracting mechanism defective (7.1.2 (e))

Rear fog lamp not working (4.5.1 (a) (ii))

Service brake efficiency below requirements (1.2.2 (a) (i))

Windscreen wiper does not clear the windscreen effectively slow in operation (3.4 (b) (ii))

Nearside Front Inner Suspension component mounting prescribed area is corroded but not considered excessive step (5.3.6 (a) (i))

Nearside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Oil leak, but not excessive (8.4.1 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Brake load sensing valve stiff (1.1.17 (c) (i))

Brake pipe corroded, covered in grease or other material rear axle (1.1.11 (c))

gearbox has slight oil leak

slight engine oil leak

Offside Seat belt not functioning as intended (7.1.2 (c))

Brake pipe corroded, covered in grease or other material rear axle (1.1.11 (c))

gearbox has slight oil leak

slight engine oil leak

Brake pipe corroded, covered in grease or other material all (1.1.11 (c))

Nearside Front Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Headlamp aim too high (4.1.2 (a))

Nearside Front Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting step inner and outer (6.2.2 (d) (i))

Nearside Headlamp aim too low (4.1.2 (a))

Rear Axle swivel pins and bushes swivel pin and/or bush excessively worn both d bar bushes (5.1.2 (b) (i))

Service brake efficiency less than 50% of the required value (1.2.2 (a) (ii)) DANGEROUS

Brake pipe corroded, covered in grease or other material all (1.1.11 (c))

Oil leak, but not excessive (8.4.1 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Brake pipe corroded, covered in grease or other material across rear axle (1.1.11 (c))

Front Brake disc significantly and obviously worn both n/s & o/s (1.1.14 (a) (i))

Headlamp aim so that beam "kick up" is not visible on the screen Left hand drive headlights fitted (4.1.2 (a))

Nearside Front Anti-roll bar linkage pin or bush excessively worn drop link lower bush (5.3.4 (a) (i))

Nearside Front Service brake excessively binding (1.2.1 (f))

Offside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Rear fog lamp missing (4.5.1 (a) (ii))

Windscreen washer not working (3.5 (a))

Nearside Front Drag link end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Wheel bearing has slight play (5.1.3 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Brake pipe corroded, covered in grease or other material across axle (1.1.11 (c))

O/S/F WHEELBEARING SLIGHTLY NOISEY

VARIOUS TYRES PERISHING ON SIDE WALLS

Nearside Rear Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Inner Rear Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Parking brake: efficiency below requirements (3.7.B.7)

Service brake: efficiency below requirements (3.7.B.7)