1992 Ford Escort

Centre Exhaust has a major leak of exhaust gases (7.1.2)

Driver's seat insecure (6.2.A.1)

Emissions not tested (7.0)

Nearside Front Anti-roll bar has excessive play in a pin/bush (2.4.G.2)

Nearside Front Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Nearside Front Suspension arm has excessive play in a ball joint (2.4.G.2)

Nearside Front Suspension arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Nearside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Front Track rod end loose (2.2.B.1d)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear Tyre not fitted in accordance with side wall instructions (4.1.D.1f)

Offside Front Anti-roll bar has excessive play in a pin/bush (2.4.G.2)

Offside Front Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Front Suspension arm has excessive play in a ball joint (2.4.G.2)

Offside Front Suspension arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Offside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Rear Seat belt anchorage prescribed area is fractured (5.2.6)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Rear Tyre(s) incorrect because different size tyres are fitted on the same axle. (4.1.A.1a)

Nearside Front constant velocity joint gaiter deteriorated (2.5.C.1a)

Offside Front constant velocity joint gaiter deteriorated (2.5.C.1a)

corrosion underneath vehicle

All position lamps not working (1.1.A.3b)

Driver's seat insecure (6.2.A.1)

Front Exhaust has a major leak of exhaust gases (7.1.2)

Front passenger seat insecure (6.2.3)

Nearside Front Lower Bonded suspension unit bonding failed and part of unit is likely to become displaced (2.4.F.2)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Headlamp aim too high (1.8)

Offside Outer Front constant velocity joint gaiter split (2.5.C.1a)

Offside Rear fog lamp not working (1.3.2b)

Rear Exhaust system not adequately supported (7.1.1)

Rear fog lamp tell tale not working (1.3.1b)

Registration plate lamp not working (1.1.5c)

Steering locking device insecure (2.2.C.1g)

Nearside Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a) DANGEROUS

Offside Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a) DANGEROUS

Nearside Outer Front constant velocity joint gaiter deteriorated (2.5.C.1a)

Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

hand brake travel high

n/s/r tyre on wrong side

n/s/r wheel bearing slightly noisey

p/steering reservoir insecure

Brake pipe inadequately supported (3.6.B.1)

Fuel system component insecure (7.2.1)

Nearside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Front Coil spring not correctly located (2.4.C.2)

Nearside Rear Wheel nut(s) missing (4.2.A.1e)

Offside Front Coil spring not correctly located (2.4.C.2)

Offside Front Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

Offside Rear Rear fog lamp not working (1.3.2b)

Rear Tyre(s) incorrect because tyres with different aspect ratios are fitted on the same axle. (4.1.A.1a)

Centre Exhaust has a minor leak of exhaust gases (7.1.2)

Centre Exhaust has part of the system slightly deteriorated (7.1.1a)

Offside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)