1992 Rover Mini

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Rear Position lamp not working (4.2.1 (a) (ii))

Nearside Registration plate lamp does not illuminate simultaneously with the position lamps (4.7.2 (a))

Offside Registration plate lamp does not illuminate simultaneously with the position lamps (4.7.2 (a))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Exhaust carbon monoxide content at idle exceeds default limits (8.2.1.2 (b))

Exhaust hydrocarbon content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Front Wheel bearing has slight play (5.1.3 (a) (i))

Exhaust emissions carbon monoxide content excessive (8.2.1.2 (b))

Nearside Front suspension has excessive play in a upper suspension ball joint (2.5.B.1a)

Nearside Headlamp not working on dipped beam (1.7.5a)

Offside Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Service brake: efficiency below requirements (3.7.B.7)

rear brake recording little or no effort (3.7.B.5a)

Nearside Rear Radius arm has slight play in a pin/bush (2.4.G.2)

slight corrosion to rear pannel

Nearside Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a)

Nearside Front suspension has excessive play in a upper suspension ball joint (2.5.B.1a)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Rear Radius arm has slight play in a pin/bush (2.4.G.2)

slight corrosion to rear pannel

Centre Exhaust has a major leak of exhaust gases (7.1.2)

Exhaust emissions carbon monoxide content excessive (7.3.B.1a)

Nearside Front Seat belt anchorage prescribed area is inadequately repaired (5.2.6)

Nearside Front Sub-frame attachment rubber mounting bonding deteriorated resulting in excessive movement (2.4.G.2)

Nearside Front Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Front position lamp(s) not working (1.1.A.3b)

Offside Front Sub-frame attachment rubber mounting bonding deteriorated resulting in excessive movement (2.4.G.2)

Offside Front Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Subframe mounting prescribed area is inadequately repaired (2.4.A.3)

Offside Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a)

Windscreen washer provides insufficient washer liquid (8.2.3)

Windscreen wiper not operating automatically when switched on (8.2.1b)

rear brake application uneven (3.7.B.2)

Nearside Front suspension has slight play in a lower suspension ball joint (2.5.B.1a)

Nearside Front suspension has slight play in a upper suspension ball joint (2.5.B.1a)

Various plates & new sills fitted are coverd with sealer, unable to see weld, o/s rear of outer sill, fitted with screws can not tell if wellded.

n/s rear sub frame mtg, some movement when wheel rocked.

top front subframe mtgs, move when stearing rocked.